Sony Disc Player Universal Remote Codes

The universal remote makes it simple to operate a variety of devices, including TVs, DTCs, VCRs, DVRs, and AUX. This is truly wonderful because it eliminates the requirement to constantly search for the remote whenever you switch between devices.

Simply follow the straightforward instructions to enter the four-digit codes on your remote to use the services. So let’s get right to it and examine the Sony Disc Player universal remote’s operating codes.

Contents

Sony Disc Player Universal Remote Codes List

BrandCodes
Sony701
Panasonic704,710
Pioneer702

How to Program Sony Universal Remote Without Codes

All universal remote control codes are scanned in the remote during the auto search procedure. To program the control, it scans one code at a time to determine the correct remote code that works with your remote. Follow the directions below:

  1. “Switch On” the smart device like “TV” that you want the universal remote to operate.
  2. “Turn on” the remote, tap on the device button (TV, DVD, CBL and OK/SEL) for 3 seconds. The LED light indicates the device is ready to program.
  3. Point out the remote to device and click on “CH+” & “CH-“ switches. Remote will show on/off signals. Press “up” or “down” key continuously till the device will turn off.
  4. Verify the code by clicking on “power” key. Device should turn on. If it starts, try changing the channel to verify that remote is programmed correctly.
  5. Now tap the “device” button to save the code. LED of Device will blink twice for confirming the code stored.

How to Program Sony Universal Remote With Manual Method

By using the keycode we can easily program a universal remote and the keycode identifies the make and model of your equipment.

  1. First, you need to “Turn The Device On”
  2. Press the “TV” on your “Sony universal remote”
  3. Now press and hold the “Setup button” of the Universal Remote until it shows the “Light Flash” (It means it is in “Learning mode”)
  4.  Finally, enter the “Keycode” which you collected from the programming guide (Instructions Booklet)
  5. Once you’ve done this procedure, just “point your remote at the TV” and then “Press And Hold The Power” button
  6. You can release the “Power Button” whenever the screen switches off.

That’s it; the universal remote control will now operate your TV flawlessly. If it still doesn’t work, try repeating the process with a new code from the same section of the reference table.

How to Program Sony Universal Remote With Code Search

If you can’t locate the correct key code for the device immediately, you can configure your universal remote to look for it. It is a manual code that forces the remote into search mode.

  1. First of all “Turn The Device On”
  2. Now press and hold the “Setup” button
  3. Enter the “9-9-1” (three-digit) code
  4. Now hold down the “Power Button” on the remote and then press the Channel up them until the device in this case your tv “Turns Off”

Conclusion

The above procedure may take a little longer, but it is critical to find your key code. After you’ve completed the above steps, your remote should be functional for all in-room functions.

I would like to recommend that you use these remote codes on the Sony Disc Player at the end of this essay. Because it is one of the greatest options for controlling several devices at the same time.

Leave a Comment