Sony Cable Box Universal Remote Codes

The best approach to operating all of your electric appliances with a single remote is, with a universal remote. We have chosen to share the Sony Cable Box Universal Remote Codes in order to address this. We will provide the correct sony cable box codes and the appropriate instructions so that everything is carried out in a correct manner.

We can guarantee that these codes will operate as intended because specialists have tested them. Check out the procedures for connecting your remote to your cable box right now.

Contents

Sony Cable Box Universal Remote Codes List

Brand NameCodes
Hamlin/Regal222,223,224,225,226
Jerrold/G.I.201,202,203,204,205,206,207,208,218
Oak227,228,229
Panasonic219,220,221
Pioneer219,220,221,214,215
Scientific Atlanta209,210,211
Tocom216,217
Zenith212,213

How to Program Sony Universal Remote Without Codes

All universal remote control codes are processed by the remote’s scanning procedure in the auto search method. To program the control, it examines each code individually to determine which is the right one to use with your remote. The steps listed below should be followed:

  1. “Switch On” the smart device like “TV” that you want the universal remote to operate.
  2. “Turn on” the remote, tap on the device button (TV, DVD, CBL, and OK/SEL) for 3 seconds. The LED light indicates the device is ready to program.
  3. Point out the remote to your device and click on “CH+” & “CH-“ switches. Your remote will show on/off signals. Press “Up” or “Down” key continuously till the device will turn off.
  4. Verify the code by clicking on “Power” key. Device should turn on. If it starts, try changing the channel to verify that the remote is programmed correctly.
  5. Now tap the “device” button to save the code. LED of the Device will blink twice for confirming the code stored.

How to Program Sony Universal Remote With Manual Method

The universal remote may be readily programmed using the keycode, which also serves to identify the make and model of your equipment.

  1. First, you need to “Turn The Device On”
  2. Press the “TV” on your “Sony universal remote”
  3. Now press and hold the “Setup button” of the Universal Remote until it shows the “Light Flash” (It means it is in “Learning mode”)
  4. Finally, enter the “Keycode” which you collected from the programming guide (Instructions Booklet)
  5. Once you’ve done this procedure, just “point your remote at the TV” and then “Press And Hold The Power” button
  6. You can release the “Power Button” whenever the screen switches off.

That’s all there is to it; your TV should now operate flawlessly with the universal remote control. If not, try repeating the process with a new code from the same section of the reference table.

How to Program Sony Universal Remote With Code Search

You can set your universal remote control to search mode if you are unable to find the key code that operates the gadget at that moment. The remote’s entry into the search mode is compelled by a code in the manual.

  1. First of all “Turn The Device On”
  2. Now press and hold the “Setup” button
  3. Enter the “9-9-1” (three-digit) code
  4. Now hold down the “Power Button” on the remote and then press the Channel up them until the device in this case your tv “Turns Off”

Final Words

It may take a little longer to find your key code using the above method, but it is very crucial. After completing the aforementioned steps, your remote should function properly for all in-room functions.

It was all about the precise requirements for programming the Sony universal remote. Therefore, now is the time to have a headache-free experience using a single remote.

Leave a Comment