Logitech Harmony 650 Universal Remote Codes & Program Instructions

You may easily add codes to your Logitech Harmony 650 Universal Remote using the configuration methods. We’ve listed the best working methods for you so don’t have to switch over multiple resources to find your code.

Here’s the truth!

See the information below if we have elaborated the methods along with codes.

Contents

How To Setup Logitech Harmony 650 Remote

We have simple steps to configure your harmony remote and then you can easily use it. The remote will be under your control after the below steps.

  1. Chose “Add Device”
  2. Then select “Satellite” which lies under “Devices”
  3. After that chose “Beyond Platinum” which lies under “Manufacturer”
  4. Finally, you need to type the words “Explora MODE 1” or “Explora MODE 2” under the “Model”
  5. You can test the remote now and it is working now.

1. How to Program Logitech Harmony 650 Universal Remote With Auto Search

All universal remote control codes are scanned in the remote during the auto search method. To configure the control, it scans one code at a time to locate the correct remote code that works with your remote. Follow the directions below.

  1. Turn on the smart device you want to use the universal remote to control, such as the TV.
  2. To “Turn On” a device, press and hold the TV, DVD, CBL, and OK/SEL buttons for three seconds. The device is prepared to configure, according to the LED light.
  3. Use the remote to select the “CH+” and “CH-” switches. On/off indications are displayed on the remote. Continuously press the “up” or “down” key until the device turns off.
  4. Click the “power” key to confirm the code. It should start up. If it does, try a different channel to make sure the remote is configured properly.
  5. To save the code, press the “device” button now. The device’s LED will flash twice to validate the code that was entered.

2. How to Program Logitech Harmony 650 Universal Remote With Manual Method

By using the keycode we can easily program a universal remote and the keycode identifies the make and model of your equipment.

  1. You must first “Turn The Device On.”
  2. On your “Logitech Harmony 650 universal remote,” select “TV.”
  3. To put the universal remote in “learning mode,” press and hold the “Setup button” until it flashes a light.
  4. Finally, key in the “Keycode” you gathered from the programming manual. (Instructions Booklet)
  5. Simply “point your remote at the TV” after completing this step, and then “Press and Hold The Power” button.
  6. When the screen goes dark, you can release the “Power Button.”
Wasn’t that simple?
Your TV should now operate perfectly with the universal remote control. If not, try repeating the process with a new code from the same section of the data table.

3. How to Program Logitech Harmony 650 Universal Remote With Code Search

You can set your universal remote to search mode and look for the right key code if you are unable to find it at that time. The remote control is placed into search mode by a code in the manual.
  1. First of all “Turn The Device On”
  2. Now press and hold the “Setup” button
  3. Enter the “9-9-1” (three-digit) code
  4. Now hold down the “Power Button” on the remote and then press the Channel up them until the device in this case your tv “Turns Off”

Wrapping Up

Locating your key code may take a little more time using the above method, but it is very important. Your remote should function properly for all in-room functions once you have completed the listed steps.

Please get in touch with us if you need help with any universal remote codes; we’ll be happy to offer a better solution and take care of your problem as soon as we can. Visit us regularly to get updated universal remote codes.

Leave a Comment