We are trying our best to provide each and every type of universal remote control code like Galaxy Matrix TV, Directv, GE universal remote and so on. If you are searching for these types and any other type of remote codes to program with your Matrix TV then this is the best platform to connect it with your TV.
In this blog post, we are mentioning all types of galaxy matrix universal remote such as a-tv10, a-tv2, urc-1234alb, urc-1518 codes and also the methods to program. Then Why Late?
Just check the codes and apply them as per the below-mentioned methods.
Contents
Matrix TV Universal Remote 4 Digit Codes
- 0000
- 0193
- 0001
- 0190
- 0031
- 1423
- 0197
Matrix TV Universal Remote 3 Digit Codes
- 028
- 020
- 025
- 021
1. How to Program Matrix TV Universal Remote With Auto Search
All universal remote control codes are scanned in the remote during the auto search method. To configure the control, it scans one code at a time to figure out the correct remote code that works with your remote. The instructions below must be followed.
- Turn on the smart device you want to use the universal remote to control, such as the TV.
- To “turn on” a device, press and hold the TV, DVD, CBL, and OK/SEL buttons for 3 seconds. The device is prepared to configure, according to the LED light.
- Use the remote to select the “CH+” and “CH-” switches. On/off indications are displayed on the remote. Repeatedly press the “up” or “down” key until the device turns off.
- Click the “power” key to confirm the code. It should start up. If it does, try a different channel to make sure the remote is configured properly.
- To save the code, press the “device” button now. The device’s LED will flash twice to validate the code that was entered.
2. How to Program Matrix TV Universal Remote With Manual Method
- You must first “Turn The Device On.”
- On your “Matrix TV universal remote,” choose “TV.”
- To put the universal remote in “learning mode,” press and hold the “Setup button” until it flashes a light.
- Finally, key in the “Keycode” you gathered from the programming handbook (Instructions Booklet)
- Simply “point your remote at the TV” after finishing this step, and then “Press and Hold The Power” button.
- When the screen goes dark, you can release the “Power Button.”
That’s All!
Your TV should now function perfectly with the universal remote control. If not, try repeating the process with a new code from the same section of the data table.
3. How to Program Matrix TV Universal Remote With Code Search
You can set your universal remote to search mode and look for the right key code if you are unable to find it at that time. The remote control is forced into search mode by a code in the manual.
- “Turn The Device On” first.
- Hold down the “Setup” button for a minute.
- Enter the “9-9-1” (three-digit) code after which you must continue holding down the “Power Button” on the remote control until the device, in this case, your tv, “Turns Off.”
Locating your key code may take a little more time using the above method, but it is very important. Your remote should function properly for all in-room functions once you have completed these steps.
We hope that the above methods and codes can be used to configure both your preferred remote control and your Matrix TV. For Matrix TV remote control setup, those methods are used.
Conclusion
If you like this article, please leave us a comment; it will help us improve our site and reach more visitors who are waiting for their remote codes. We also accept new universal remote control codes that are working for you.
Please leave those codes in the below comment section, and we will forward them to other users by posting them on our site.