Craig DVD Universal Remote Codes

If you own a Craig DVD Player and want to program it to work with your preferred universal remote control, we’ve listed the programming techniques as well as the Craig DVD Player universal remote codes below. Basically, you may use any kind of universal remote control to run the Craig DVD Player, but you must use the proper programming techniques.

Therefore, we will discuss many code types that are compatible with this device in this blog as well as some of the best working techniques that are simple to implement.


Craig DVD Universal Remote 4 Digit Codes

  • 1036
  • 1484

Craig DVD Universal Remote Codes From Different Universal Remote Brands

RCA Universal Remote

  • 064

Sony Universal Remote

  • 042
  • 053

How to Program Craig DVD Universal Remote Without Codes

All universal remote control codes are scanned in the remote during the auto search procedure. To configure the control, it scans one code at a time to determine the correct remote code that works with your remote. Follow the directions below:

  1. Turn on the smart device you want to use the universal remote to control, such as the TV.
  2. To “turn on” a device, press and hold the TV, DVD, CBL, and OK/SEL buttons for three seconds. Your device is prepared to program, according to the LED light.
  3. Use the remote to select the “CH+” and “CH-” switches. On/off indications are displayed on the remote. Continuously press the “up” or “down” key until the device turns off.
  4. Click the “power” key to confirm the code. It should start up. If it does, try a different channel to make sure the remote is configured properly.
  5. To store the code, press the “device” button now. The device’s LED will flash twice to verify the code that was stored.

How to Program Craig DVD Universal Remote With Manual Method

The universal remote may be readily configured using the keycode, which also helps you to identify the make and model of your equipment.
  1. You must first “Turn The Device On.”
  2. On your “Craig DVD universal remote,” select “TV.”
  3. In order to put the universal remote in “learning mode,” press and hold the “Setup button” until it flashes a light.
  4. Lastly, key in the “Keycode” you gathered from the programming manual (Instructions Booklet)
  5. Simply “point your remote at the TV” after completing this step, and then “Press and Hold The Power” button.
  6. When the screen turns off, you can release the “Power Button.”

That’s it, the universal remote control will now operate your TV flawlessly. If it still doesn’t work, try repeating the process with a new code from the same section of the reference table.

How to Program Craig DVD Universal Remote With Code Search

You can set your universal remote to search mode and look for the right key code if you are unable to find it at that time. The remote control is pushed into the search mode by a code in the instructions.

  1. First of all “Turn The Device On”
  2. Now press and hold the “Setup” button
  3. Enter the “9-9-1” (three-digit) code
  4. Now hold down the “Power Button” on the remote and then press the Channel up them until the device in this case your tv “Turns Off”

Final Words

Finding your key code may take a little more time using the above method, but it is very crucial. Your remote should function properly for all in-room functions once you have completed the aforementioned steps. Please get in touch with us if you need help with any universal remote codes; we’ll be happy to offer a better solution and take care of your problem as soon as we can.

Visit us frequently to acquire updated universal remote codes.

Leave a Comment